Ian Thompson
2017-07-03 15:00:40 UTC
Apologies if this has already been addressed and I haven't searched the archives enough.
I'm using ...
Fabric3 1.13.1.post1
Paramiko 2.2.1
to update and maintain a set of 36 copper networked embedded Linux boards.
Generally all works well but occasionally a parallel "put" of a file ~ 30kbytes will indicate no errors but some boards will end up with a zero byte file. Usually it's a block of four or five boards with consecutive ip addresses that fails but not necessarily the same block.
Has this been seen before?
How would I go about debugging this?
Regards
Ian T.
I'm using ...
Fabric3 1.13.1.post1
Paramiko 2.2.1
to update and maintain a set of 36 copper networked embedded Linux boards.
Generally all works well but occasionally a parallel "put" of a file ~ 30kbytes will indicate no errors but some boards will end up with a zero byte file. Usually it's a block of four or five boards with consecutive ip addresses that fails but not necessarily the same block.
Has this been seen before?
How would I go about debugging this?
Regards
Ian T.